MS1000 Linear Heat Detection Selector

Pick the cable, interface and end unit for a UL / FM / Ex project, check the layout and watch how the system reacts in 3D. Data from the P.T.S catalogue (ver 202606) and the UL, FM, ATEX and IECEx certificates.

Quick start

Approvals required

UL FM

CE and EAC apply to every variant. Leave both off if the project only needs CE / EAC.

Environment

Indoor, dryWarehouses, plant rooms, ceilings Outdoor / chemicalTunnels, conveyors, corrosive air, CR/OD jacket Strong EMISubstations, drives, EP anti-EMI cable

Hazardous area

Explosive atmosphere (Ex)Gas or dust zone, needs the MS1000-P (Ex) end unit

Temperature

Highest ambient

Lowest ambient

Protected layout

Area (ceiling) Proximity

Width (m) Length (m)

Area mode sizes the cable runs from the FM spacing for the chosen alarm temperature. Each zone is limited to 500 m of cable.

STANDBY

Elapsed: 0.0 s
Hot spot: 25 °C
Loop: ≤ 20 mA

Drag to orbit · scroll or pinch to zoom

Illustration of the selected configuration. Cable colours are illustrative. Fire response time in the animation follows the catalogue's direct-flame figures for the chosen alarm temperature.

Selection logic is derived from the supplied P.T.S catalogue and the UL, FM, ATEX and IECEx documents. Limits marked “assumed” are not stated unambiguously in the catalogue and should be confirmed with P.T.S. The final design, spacing and approvals remain the responsibility of the system designer and the authority having jurisdiction.